| |
| |
|
Loose Revolver Barrels and Lost Sights
|
| |
| Multi piece revolver barrels can provide a weight savings by using various materials. Many shooters want to reduce weight on a carry gun. However, experience has shown that these barrel assemblies frequently come loose. Another problem is that it takes specialized tooling to correct the problem. At DLS inc the goal is to solve problems with design improvements so they don't occur in the field. The loose barrel problem can be solved with proper fitting and installing a barrel lock. While this custom work is being done, the barrel can also be given a precision, recessed and protected target crown, instead of the difficult to clean step crown. In addition, while the barrel is out of the frame the forcing cone can be properly cut and polished for best performance. |
| Another problem that arises too often with spring loaded interchangeable front sights is they get caught on the top lip of the holster while re-holstering. When the revolver is pushed into the holster the front sight becomes unlatched from the retaining pin. Then when the revolver is drawn again, the front sight falls out of the gun during the draw stroke, and is often lost under field conditions. This is another concerning problem that should be prevented before it occurs. Once the correct front sight is selected to achieve proper zero on target, then the front sight should receive an additional cross pin to rigidly secure it in place, even during rough use. The sharp, fragile and shallow notch rear sight can be replaced with a DLS inc heavy duty rear sight to solve those problems. |
|
|
|
|
|
|
|
)
)
)
)